VC Slew Limiter Partial Kit

VC Slew Limiter Partial Kit

CAREFUL! THIS IS NOT A FULL KIT

The partial kit of our VC Slew Limiter module. Includes PCB/Panel Set + Rare parts.

A voltage-controlled slew limiter, AKA Lag Processor.

A slew limiter is a device that smoothes an incoming signal, limiting the maximum rate of the output voltage over time. It is widely used with pitch CVs to obtain portamento and CV slides but is also very useful for converting a gate signal into a basic envelope.

FEATURES

  • A Slew limiter is a device that smoothes an incoming signal, limiting the maximum rate of change of the output voltage over time.
    It is widely used with pitch CVs to obtain portamento but is also very useful for converting a gate signal into a basic envelope.
  • The module has independent time controls for rising and falling voltages, each with its own CV.

  • The “SHAPE” control allows you to change the curve response from linear to logarithmic.
Out of stock
€42.00

 

This Partial kit contains:

1 VC Slew Limiter PCB Set
1 Potentiometer Single gang 100k Linear PCB
2 Sliding Potentiometer 30mm 100k Linear PCB
2 Toggle Switch Cap Red
4 Jack 3.5mm Mono PCB
1 Knob Davies White T36 Shaft
1 Black Bananuts for Pots
3 Black Bananuts
1 Red Bananuts

For further information on this module please refer to the website.

For documentation relating to older versions of this module please contact: support@befaco.org

Designed and assembled by hand with love in Barcelona.

Size | HP
6
Depth (inc. connector) | mm
30
DIY Level
Easy
PTDIY012

16 other products in the same category: