Pedal Pow DIY Kit

SPECS

• 1U Intellijel format
• Current needs: +12V: 30mA, -12V: 30mA
• Width: 6 HP
• Depth: 30mm (including power connector)
• Aluminiun, heat-treated front panel
• Designed, kits prepared and completed modules assembled in Barcelona

IMPORTANT NOTES ON CURRENT CONSUMPTION AND POWER.

The PEDAL POW is a power supply that relies on your Eurorack power supply, and therefore, its power cannot exceed that of your Eurorack. 

Additionally, your Eurorack power supply must be able to power all your modules, as well as anything you connect to the PEDAL POW. 

The power that PEDAL POW provides will be shared with all the modules on your modular synth, converting the +12 Volt power rail to 9 volts.

Pedal power can supply a maximum of 500 mA per output. As a rule of thumb, each mA on the Pedal Pow will draw approximately 0.8 mA from your +12V power bus. Therefore, to utilize the full 500 mA, you will need to provide 400 mA from your +12V rail, since 500 mA * 0.8 = 400 mA.

To simplify your calculations, please refer to the following table, where you can easily determine your current needs.