VC Slew Limiter DIY Kit

DIY kit version of our VC Slew Limiter Eurorack module. 

The kit includes all the necessary parts to make a completed module including power cable and four of our bespoke Knurlies M3 rack screws.

In order to facilitate easy assembly all our kits come with hex nuts and not with round nuts seen on our assembled modules.

60,00 €

INTRODUCTION
A voltage controlled slew limiter, AKA Lag Processor.

 

FEATURES


A Slew limiter is a device that "smoothes" an incoming signal, limiting the maximum rate of change of the output voltage over time.

It is widely used with pitch CVs to obtain portamento but is also very useful to convert a gate signal into a basic envelope.

The module has independent time controls for rising and falling voltages, each with it’s own CV.

rampage-1.png

 

The “SHAPE” control allows you to change the curve response from linear to logarithmic.

   

 

FURTHER INFORMATION

For documentation relating to older versions of this module please contact: befacosynth@gmail.com

Designed with love in Barcelona.

The VC Slew Limiter is also available as an assembled module.

 

COMPLETING THE PROJECT

By buying one of our kits you claim that you have the necessary knowledge to properly assemble and solve problems derived from it.

If you need further technical assistance please take a look to our basic troubleshooting guide.

In case you cannot get the module to work, DON'T PANIC! You can get our Happy Ending Pack that includes advanced troubleshooting, repair, technical service, parts and reshipping back to you.

Current draw+12V: 10mA, -12V: 10mA
Size | HP6 HP
Depth (inc. connector) | mm31mm

Related Products