Sampling Modulator DIY Kit

DIY kit version of our Sampling Modulator Eurorack module. 

The kit includes all the necessary parts to make a completed module including power cable and two of our bespoke Knurlies M3 rack screws.

In order to facilitate easy assembly all our kits come with hex nuts and not with round nuts seen on our assembled modules.

120,00 €

INTRODUCTION
The Sampling Modulator is a multi-function module that lies somewhere between a VCO, a Sample & Hold, and an 8 step trigger sequencer.

 

FEATURES

This module can function as:

Sequencer Clocked Sample & Hold
In this mode it acts like a regular Sample and Hold (S&H) but since it is “sequencer clocked”, it is capable of much more interesting patterns than the usual S&H melodies.

The CLOCK input can work in two ways:
1. As a typical clock
2. In “positive going hard” sync mode allowing you to create shuffling and polyrhythmic effects.

The HOLD input can be used to keep certain notes playing.

Analog Down-Sampling Effect
In this mode (with the clock running at audio rates) you can go from nasty and harsh sampling rate reduction to an almost clean signal. (The clock run up to 25Khz without external CV and up to 200Khz with CV on the input).

Sampling Modulator/Shaper
Thanks to the V/Oct clock, by feeding a simple waveshape such as a sine wave to IN, and pitch CV to the VCO as well as to the Sampling Modulator CV input, their related frequencies and aliasing caused by the sampling rate reduction are capable of creating clangorous metallic sounds, 8 bit textures and much more.

The game becomes much more interesting when you try to destroy the wave by flipping on and off the switches of the sequencer (which at times can make it sound like three VCOs running in unison).

To understand how the Sampling Modulator works, keep in mind that we are working with a temperature compensated ramp core VCO with more than 4 octaves of tracking. This allows the timbre to stay the same while you move through the scale as the internal and external VCOs are synced in a fashion similar to “frequency related sampling rate modulation”.

8 step trigger sequencer
A simple utility trigger generator which is also useful as clock divider. The switches have three positions: On, Off and Reset (which resets to the first step for non 4/4 signatures)

Unusual V/oct VCO
You can use the trigger outputs as a pulse VCO. Flipping the switches on and off the switches can offer a lot of interesting timbral changes.

A veritable Swiss Army Knife in just 8HP!

 

FURTHER INFORMATION

For further information about this module, please see the attached User Manual and Assembly Guide in the 'Download' section above.

For documentation relating to older versions of this module please contact: befacosynth@gmail.com

Designed with love in Barcelona.

The Sampling Modulator is also available as an assembled module.

 

COMPLETING THE PROJECT

By buying one of our kits you claim that you have the necessary knowledge to properly assemble and solve problems derived from it.

If you need further technical assistance please take a look to our basic troubleshooting guide.

In case you cannot get the module to work, DON'T PANIC! You can get our Happy Ending Pack that includes advanced troubleshooting, repair, technical service, parts and reshipping back to you.

 

BLOCK DIAGRAM

Current draw+12V: 48mA, -12V: 18mA
Size | HP8 HP
Depth (inc. connector) | mm40mm

Samp. Mod. Assem. Man. - 04/17

Sampling Modulator Assembly Manual - Updated 04/17

Download (579.41k)

Related Products