Crush Delay DIY Kit

DIY kit version of our Crush Delay Eurorack module. 

The kit includes all the necessary parts to make a completed module including PCB, components, aluminium front panel, power cable and a set of our bespoke Knurlies M3 rack screws.

129,71 €

INTRODUCTION

This is the second iteration of our Crush Delay. It is an echo-delay unit based on the PT2399 IC, which although able to offer 400 ms of clean delay, has a special talent for generating digital garbage and noise! Our beautiful freak features multiple circuit bends to the chip, an FX send & return, and up to 2 seconds of filthy digital delay.

 

FEATURES

The new Crush Delay features two VCAs to control the amount of signal sent to the delay. The first is routed to both the dry/wet mix and the delay, and the second directly to the delay. Combining the second VCA and the FX Send output allows for external feedback routings (see block diagram below).

The biggest improvement from the previous version of the module is to the control of PT2399 itself through the application of circuit bending techniques. It has an improved and extended speed control, offering a wider range and smoother control of the Crush section, converting this unit into a VC digital garbage generator!

It also includes three gate controllable switches to enable the three circuit-bends on the chip providing a high level of control over the digital noise, glitches and general nasty mayhem!

The VC feedback features an automatic gain control to keep levels stable at any feedback level.

 

FURTHER INFORMATION

For documentation relating to older versions of this module please contact: befacosynth@gmail.com

Designed with love in Barcelona.

The Crush Delay is also available as an assembled module.

 

COMPLETING THE PROJECT

By buying one of our kits you claim that you have the necessary knowledge to properly assemble and solve problems derived from it.

If you need further technical assistance please take a look to our basic troubleshooting guide.

In case you cannot get the module to work, DON'T PANIC! You can get our Happy Ending Pack that includes advanced troubleshooting, repair, technical service, parts and reshipping back to you.

 

BLOCK DIAGRAM

Current draw75mA at +12V rail // 35mA at -12V rail
Size | HP11HP
Depth (inc. connector) | mm47mm

Related Products